The model is created from the rectangular sheet of a paper. You can, for example to use the usual sheet with �4 format . At the first stage we shall mark the middle of this paper. Let's fold it in half. At the following stage of folding we shall bend corners to the line, marked at the first stage. Thus creases goes from the centre of the square.

In front and behind we shall lift upwards on the one layer of the paper. These creases fix two triangles received on the previous step. For simplicity of performance of the following action we shall remove the superfluous paper on edges of model. By the following action we shall open and squash the pocket, which represents the model.

Let's divide among themselves boards and sail of the boat. That we fold, becomes subsequently the boards of boat. And top part, by which we fold at the given stage will be the sail. So, now you can choose, how much papers give to the sail, and how much - to the boards. If you will carry out the crease below, the sails will be more.

Further we shall repeat once again sixth action on opening of the pockets. At the following stage is shown how to open the boat. For this purpose it is necessary to stretch the model.

The boat is ready. I would recommend to give to the model additional space. For this purpose it is enough to give the part of the paper from the bottom part of the boat's boards to the sail. In this case the model it will turn out by stable on water.

Besides it, it is possible to give additional stability to the boat a little having loaded her. For example having put branches on bottom of the boat. Only it will be necessary to load her in regular intervals, that she has not given a roll.

If you have interested in swiming models, you can see how fold the classical model of the steamship or author's model by Larisa Perelekhova "The Novgorod ship", which is submitted in the PDF format.